Updated
EV Charger Showing Error Light
Your EV charger is displaying a red light, flashing pattern, or error code on its display.
Find an electrician
What's happening?
EV chargers use LED lights and displays to communicate their status. A red light or error indication means the charger has detected a fault and has stopped or will not start charging as a safety precaution. The specific pattern or code varies by manufacturer.
What usually causes it?
- Earth fault detected by the charger's internal RCD
- Over-temperature — charger has overheated
- Communication error between charger and vehicle
- Supply fault — voltage or frequency out of range
- Internal hardware fault — relay, contactor, or sensor failure
- Charger firmware error requiring a restart or update
Is it dangerous?
The error light means the charger has detected a potentially unsafe condition and has protected you by stopping. This is the charger working as designed. Do not attempt to bypass the error. If the error is an earth fault or over-temperature warning, the charger should be checked before resuming use.
Can I fix it myself?
Note the exact light colour, pattern, and any error codes. Check the manufacturer's app and manual for what the error means. Try restarting the charger by switching the isolator off for 60 seconds and back on. Check the charging cable for damage. If the error is temperature-related, wait for the charger to cool down — direct sunlight on a hot day can cause overheating.
When should you call an electrician?
Call an electrician if the error persists after restarting, if the error code indicates an earth fault, if the charger shows a hardware error that the manufacturer confirms needs an electrical inspection, or if the error appeared after a power surge or electrical work on the property.
What will the electrician actually do?
- Read and interpret the charger error codes
- Test the supply circuit for voltage, frequency, and earth integrity
- Check the charger's internal protection devices
- Inspect wiring connections for heat damage or looseness
- Liaise with the manufacturer for diagnosis and potential warranty replacement
- Replace or repair the charger if the fault is confirmed as a hardware issue
What will it cost to fix?
£80–£280
Diagnosis and supply-side repairs are at the lower end. If the charger needs warranty replacement, the electrician may charge for the visit and the disconnection/reconnection. Check warranty coverage before authorising work on the charger itself.
Find an electricianFrequently asked questions
We’re happy to answer all your questions.
What does a red light on my EV charger mean?
A red light typically indicates a fault. The exact meaning depends on the manufacturer and model. Check the manual or app for the specific error code. Common causes include earth faults, overheating, and communication errors.
Can I ignore the error and keep charging?
No. The error light means the charger has stopped for safety reasons. Attempting to bypass it could be dangerous. Get the fault diagnosed before resuming charging.
Should I contact the manufacturer or an electrician?
Contact the manufacturer first for interpretation of the error code. They will advise whether it is a charger fault (warranty) or an installation issue (electrician). Many faults are resolved by the manufacturer remotely via firmware updates.
Could a power surge damage my EV charger?
Yes. Power surges from lightning or grid events can damage the charger's electronics. A Type 2 surge protection device (SPD) at the consumer unit is recommended for EV charger installations and is required by BS 7671 in many cases.
Need an electrician?
Compare local electricians on Tradehand — coverage areas, accreditations and phone numbers, no middleman.
Find an electrician