Skip to main content
Loose Carpet On The Stairs

Loose Carpet On The Stairs

The carpet on the stairs has come loose at the edge, over the nosing or in the gap at the back of the tread.

Caution · Fixed by a flooring fitter

Updated

What's happening?

Stair carpet is held by grippers along the back of each tread and the bottom of each riser, with the carpet stretched or tucked into that angle. It comes loose when the gripper pins lose their hold, when the carpet has stretched, when the nosing has worn through the pile, or when the underlay has compressed so the carpet slips on the edge. A fitted stair carpet that moves underfoot is a trip risk, so a loose section should be treated as urgent rather than cosmetic. A fitter will usually find that one tread or a run has come away rather than the whole staircase, and re-stretching or replacing gripper and underlay at the failed steps is often enough. Worn nosings may call for new carpet on those treads.

What usually causes it?

  • Gripper pins that have lost their hold or the gripper has worked loose from the stair
  • Carpet that has stretched and is now slack across the tread and riser
  • A worn nosing where the pile has been rubbed through at the edge
  • Compressed or torn underlay allowing the carpet to slide at the front of the tread
  • A carpet that was fitted too tight or not tucked into the gripper at the angle
  • Loose or squeaking treads under the carpet moving the whole covering

Is it dangerous?

Yes. Loose stair carpet is a trip and slip hazard. HSE's workplace flooring guidance expects floors to be in good condition and free from obstructions, and a home staircase should meet the same test. Do not use a staircase with a loose or lifting step carpet until it is secured.

Can I fix it myself?

1. Walk the stairs and mark every tread where the carpet moves or has lifted. 2. Do not tape or glue loose carpet: it fails and leaves residue. 3. If gripper pins show, cover them. 4. Take extra care going down, and keep the stairs clear. 5. If the carpet is slack all over, or the treads creak, get a fitter to look rather than patching. 6. Use a stair gate or avoid the stairs if someone is unsteady.

When should you call a flooring fitter?

Call a carpet fitter promptly for any loose stair carpet, and the same day if a tread moves underfoot or the nosing has worn through. Say if the treads also creak, because a carpenter may need to look at the stairs themselves.

What will the flooring fitter actually do?

  • Lift the carpet at each failed tread and inspect the gripper, underlay and stair
  • Replace worn or loose gripper and torn underlay at the treads that need it
  • Re-stretch and re-fix the carpet, tucking it properly into the angle
  • Replace worn sections or treads where the nosing has gone through the pile
  • Flag loose or squeaking treads that need a carpenter

Who fixes this

Questions people ask

How do you fix loose stair carpet?

A fitter lifts the carpet at the loose treads, replaces the gripper or underlay if they have failed, and re-stretches and fixes the carpet. Gluing or taping loose carpet is only a short-term measure.

Why is my stair carpet loose?

Usually the carpet has stretched, the gripper has lost its hold, or the underlay has worn at the edge of the tread. Heavy daily use makes it worse.

Is loose stair carpet dangerous?

Yes, it is a trip risk. HSE's flooring guidance expects floors to be in good condition and free from obstructions.

Sources & References

  1. Designing Buildings: How to fit carpet
  2. UK Flooring Direct: Carpet installation guide
  3. HSE: Flooring (floors in good condition and free from obstructions)

Need a flooring fitter?

Describe the job and get a fixed price from a local flooring fitter.