
Laminate Floor Creaking, Clicking Or Popping
Low risk · Fixed by a flooring fitter
What's happening?
A laminate floor is not fixed down: it floats on an underlay and moves slightly as the temperature and humidity change. Noise comes when that movement is blocked or when something under the floor is uneven. A floor laid without the expansion gap the maker specifies around the walls, pipes and doorways will rub against skirting and doorframes. A floor laid on a subfloor that is not flat will flex at the high and low points. A worn or compressed underlay, a dried-out subfloor or a loose board under the floor all produce creaks. It is a nuisance rather than a hazard, but a floor that makes noise is telling you where it is touching or where it is unsupported. Some manufacturers give flatness limits of 2 mm over a metre, and a gap of 8 to 10 mm all round.
What usually causes it?
- No expansion gap, or too small a gap, so the floor rubs against walls, skirting or pipes
- A subfloor that is not flat, so the floor flexes at high and low spots
- Worn, compressed or missing underlay under the boards
- Loose or squeaking floorboards or chipboard under the laminate
- Seasonal movement as heating dries the air in winter and the boards shrink
- Boards that were clicked together badly or have lost their joint
Is it dangerous?
No. Creaking and clicking are noises, not a danger. A floor that has lifted or buckled is different, because the raised edges can trip people and water may be involved.
Can I fix it myself?
1. Find where it is loudest and whether it is at a wall, a doorway or the middle of the room. 2. Check whether the skirting or a pipe is touching the floor edge. 3. If a gap is missing, a fitter may need to trim the edge and refit the skirting. 4. Do not nail or screw through a floating laminate floor. 5. Note whether the noise changes with weather or heating.
When should you call a flooring fitter?
Call a flooring fitter if the noise is widespread, if the floor has gaps or has lifted, if boards are moving, or if the floor was fitted recently and may not have been fitted to the maker's instructions.
What will the flooring fitter actually do?
- Locate the noisy area and check the expansion gaps against the skirting, doors and pipes
- Check the subfloor for flatness and for loose boards or sheets beneath the floor
- Lift the affected boards and replace worn underlay or correct high and low spots
- Re-lay the boards with correct gaps and clicked joints
- Advise whether the whole floor needs relaying, if it was fitted without proper gaps
Who fixes this
- Laminate flooring fitting
- Floor repair and board replacement
Questions people ask
Why does my laminate floor creak?
How big should the gap around a laminate floor be?
Can I fix a creaky laminate floor without lifting it?
Sources & References
Before you book, read how to check a tradesman is legit.


