Updated
Socket Hot To Touch
A plug socket in your home feels hot when you touch it, even when nothing is plugged in.
Find an electrician
What's happening?
A socket that is hot to the touch is overheating. A slight warmth when a high-draw appliance is plugged in (such as a heater or kettle) can be normal, but a socket that is noticeably hot — especially when lightly loaded or with nothing plugged in — indicates a fault. The heat is generated by electrical resistance at a poor connection, and it can escalate quickly.
What usually causes it?
- Loose terminal connections at the back of the socket creating resistance
- Damaged or corroded contacts inside the socket
- Overloaded socket drawing excessive current
- Backstab connections that have worked loose
- Faulty wiring in the back box — nicked or compressed cables
- Using a single socket for a high-draw appliance via an adaptor
Is it dangerous?
Yes. A hot socket is a sign of excessive resistance and potential arcing. If left unchecked, the heat can melt the socket plastic, damage the wiring insulation, and cause a fire. Even if the socket appears to work normally, heat means there is a problem. If the socket is hot with nothing plugged in, the fault is in the fixed wiring and needs urgent attention.
Can I fix it myself?
No. Stop using the hot socket immediately. Unplug any appliances from it and avoid inserting plugs into it. If the socket is very hot, turn off the circuit at the consumer unit. Do not attempt to open the socket yourself. Note whether the socket is hot when loaded (something plugged in) or hot with nothing plugged in — this is useful information for the electrician.
When should you call an electrician?
Call an electrician within 24 hours if the socket is hot when loaded. If it is hot with nothing plugged in, or if you notice any burning smell or discolouration, call an emergency electrician immediately. A hot socket should never be left uninvestigated.
What will the electrician actually do?
- Remove the socket faceplate and inspect all terminal connections
- Check for signs of overheating — discoloured insulation, melted plastic, charred terminals
- Tighten all connections to the correct torque specification
- Replace the socket if the internal contacts or housing are damaged
- Test the ring circuit to ensure it is intact and properly connected
- Check if the circuit is overloaded and advise on additional sockets or circuits if needed
What will it cost to fix?
£60–£180
Socket replacement with connection inspection is a standard job. Costs increase if the back box or wiring needs replacing due to heat damage.
Find an electricianFrequently asked questions
We’re happy to answer all your questions.
Is it normal for a socket to be warm?
A very slight warmth when a high-draw appliance is plugged in can be normal. However, a socket that is noticeably hot, hot to the point of discomfort, or hot with nothing plugged in is not normal and needs checking.
Can I use the socket if it is only slightly warm?
If it is very slightly warm with a high-draw appliance like a heater, this may be acceptable. But monitor it — if it gets hotter over time or feels warm with normal loads, stop using it and call an electrician.
What is causing the heat?
Heat in a socket is almost always caused by a loose or corroded connection creating electrical resistance. Current flowing through a poor connection generates heat proportional to the resistance and the square of the current — so higher loads produce much more heat.
Should I check all my other sockets?
Yes, it is a good idea. Feel the faceplates of your other sockets while they are in use. If any feel warm, make a note and mention them to the electrician.
Need an electrician?
Compare local electricians on Tradehand — coverage areas, accreditations and phone numbers, no middleman.
Find an electrician