Why does my washing machine trip the electrics?

The most common cause is a failed heating element. Other causes include water leaks reaching electrical parts, worn motor brushes, or a failed suppressor capacitor.

Do I need an electrician or an appliance repair person?

If the trip only happens with the washing machine, you likely need an appliance engineer. If other appliances also trip the RCD, or if the problem is intermittent, start with an electrician to check the circuit.

My washing machine trips during the spin cycle — why?

This usually points to a motor fault, often worn carbon brushes. As the motor speeds up during spin, the worn brushes create arcing that the RCD detects as an earth fault.

Can I use the washing machine on a different socket?

You can try to confirm the fault is in the machine rather than the socket. If it trips on a different socket (on a different circuit), the machine is faulty. However, do not use extension leads for washing machines as a permanent solution.

Caution

Updated 30 August 2026

Washing Machine Tripping The RCD

Your washing machine trips the electrics every time you run a cycle — or at a specific point during the wash.

What would yours cost?

We'll tell you the price for this, then find a local electrician to do it.

on your first booking

Get my instant quote

What's happening?

Washing machines combine electricity, water, and high-speed motors — making them one of the most common causes of RCD tripping in UK homes. When a washing machine trips the RCD, it is usually because water has reached an electrical component inside the machine, or the heating element has failed. The timing of the trip during the wash cycle can help identify the cause.

What usually causes it?

Heating element has failed and is leaking current to earth
Water leak inside the machine reaching electrical connections or the motor
Worn or damaged door seal allowing water to escape internally
Carbon brushes on the motor are worn and causing arcing
Suppressor capacitor has failed (common on older machines)

Is it dangerous?

A washing machine that trips the RCD should not be used until the fault is identified. Water and mains electricity inside the machine is a dangerous combination. While the RCD is protecting you by cutting the power, the fault could worsen and potentially cause a fire. Unplug the machine and do not use it until it has been repaired.

Can I fix it myself?

Note when during the cycle the trip occurs — this helps diagnosis. If it trips at the start, the suppressor or motor may be faulty. If it trips during the wash, the heater element may be the cause. If it trips during spin, motor brushes are likely. You can check for obvious water leaks underneath the machine. Appliance repair is different from electrical work — you may need an appliance engineer rather than an electrician.

When should you call an electrician?

Call an electrician if you think the fault is in your home's wiring or consumer unit rather than the washing machine itself. If the RCD trips with other appliances too, the issue may be the RCD or the socket circuit. If the trip only happens with the washing machine, call an appliance repair engineer for the machine and an electrician for the socket and wiring.