
Induction Hob Tripping the Electrics
Caution · Fixed by an electrician
What's happening?
An induction hob is a high-power appliance wired into the cooker circuit, often shared with a built-in oven. Electrical Safety First says cookers, ovens and hobs over 2 kW should be on their own dedicated circuit, and the Health and Safety Executive says that if an RCD trips it is a sign of a fault, so never bypass it. When a new or old hob trips the RCD or breaker, there are three places to look. The hob can have a fault inside it, the connection between hob and circuit can be loose, damaged or wrongly made, or the circuit can be overloaded or shared with other loads. The trip pattern helps: tripping the moment the hob switches on, only on certain zones, or only when the oven runs as well.
What usually causes it?
- A fault inside the hob that leaks current to earth, which usually trips the RCD as soon as it is switched on
- A loose, damaged or wrongly made connection at the hob terminal block or the connection unit
- A hob and oven together drawing more current than the circuit and its breaker are rated for
- A circuit shared with other loads, when Electrical Safety First says hobs over 2 kW should have their own dedicated circuit
- A damaged flex, or a flex pinched between the hob and the worktop cut-out
- An RCD or RCBO that is itself failing, shown when the same trip happens with the hob disconnected
Is it dangerous?
The trip is the protection working, so never bypass it. A hob run without a proper earth connection can leave accessible metalwork live, and the Health and Safety Executive says to check the system before using it again after an RCD trip. Electrical Safety First says that if there is arcing, blown fuses, tripping breakers or the appliance feels too hot, unplug it and contact a qualified technician.
Can I fix it myself?
1. Switch the hob off at its isolator or switch, then reset the breaker or RCD once. 2. Note exactly when it trips: as soon as the hob goes on, only when one zone is used, or only with the oven on. 3. Check that no pan, cable or loose item is trapped against the hob. 4. If it trips again, leave the hob off and use another way to cook. 5. Do not lift the hob out or touch its connection. Book an electrician to test the circuit and the hob.
When should you call an electrician?
Call an electrician as soon as the hob trips more than once, trips the moment it is switched on, or shares a circuit with other loads. If the circuit tests clean, the electrician will send you back to the hob manufacturer or an appliance engineer for the hob itself. Book the same day if there is any burning smell or the hob switch or flex feels hot.
What will the electrician actually do?
- Isolate the hob circuit and test insulation resistance and earth continuity on the circuit and the hob flex
- Disconnect the hob and see whether the trip stays, which separates a hob fault from a circuit fault
- Check the rating of the circuit and its breaker against the hob and oven together
- Re-make or replace damaged connections, the connection unit or the flex
- Move the hob onto its own circuit, or fit a suitable RCBO, where the circuit is shared or overloaded
Who fixes this
What it usually costs
- Electrical Fault Finding Cost
- Priced on survey
Questions people ask
Why does my induction hob trip the RCD?
Does a hob need its own circuit?
Can I bypass the RCD to keep cooking?
Where can a switch or socket go near a hob?
Sources & References
Before you book, read how to check an electrician is qualified.



