
Tile Spacers Left In After Tiling
Low risk · Fixed by a tiler
What's happening?
Tile spacers hold the joint width while the adhesive sets, and the manufacturers' instruction is to take them out before grouting. Instarmac says to remove all spacers and brush or blow away loose adhesive from the joints before grouting, and does not recommend tiling over spacers because it can cause colour variation and only a thin application of grout. Mapei's grout troubleshooting guide lists tile spacers left in the grout joint as a cause of grout cracking, with the remedy to remove all spacers before grouting. The joint has to be filled with grout to its full depth to do its job, and a plastic spacer in it is a weak, visible point. If spacers have been grouted over, the grout over them can crack, shade or look thin, and the fix is to rake out those joints and re-grout.
What usually causes it?
- Spacers left in because the adhesive set before they were pulled out, making them hard to remove
- Tiling and grouting done in one go, without checking the joints are clear of spacers and loose adhesive
- Spacers deliberately left in and grouted over, which grout makers advise against
- Grout applied before the tile adhesive had fully cured, with spacers still in the joint
- A thin layer of grout over a spacer that shows through as a shadow or a hairline crack
Is it dangerous?
Not dangerous. The consequence is a weaker joint: grout over a spacer is thin, shades differently and can crack, and a cracked joint in a bathroom or kitchen lets water get behind the tiles.
Can I fix it myself?
1. Check the joints for lines, shadows or small cracks that follow the spacer positions. 2. If the grout has not cured, remove it and the spacers before it sets. 3. If it has set, rake out the grout over the spacers with a grout rake, taking care not to chip the tile edges, and pull the spacers out. 4. Brush out loose adhesive and dust, then re-grout the cleaned joints. 5. If a lot of joints are affected, or the tiles are in a shower or wet room, ask a tiler to re-grout.
When should you call a tiler?
Call a tiler if many joints show spacers, if the grout is cracking, if the area is a shower or wet room, or if you do not want to rake out grout beside expensive tiles. A tiler can re-grout the joints and reseal the corners.
What will the tiler actually do?
- Inspect the joints to find where spacers were left in and where grout has cracked or shaded
- Rake out the affected grout to clear the spacers and loose adhesive
- Clean the joint edges so the new grout can bond to the tile
- Re-grout the joints to full depth, matching the colour as closely as possible
- Reseal movement joints and corners that need flexible sealant, not grout
Who fixes this
- Regrouting and resealing
- Tile repair and replacement
Questions people ask
Should tile spacers be left in?
What happens if spacers are left in the grout?
When should spacers come out?
How do I get spacers out after the grout has set?
Sources & References
Before you book, read how to check a tradesman is legit.


