Skip to main content
Draught Under The Front Door

Draught Under The Front Door

Cold air comes in under a front door, or there is a visible gap at the threshold, even with the door shut and locked.

Low risk · Fixed by a handyman

Updated

What's happening?

A draught under a front door is a gap at the bottom of the door that has opened up or never was sealed. A door is built with a small clearance so it can swing over the floor, and a brush strip, a rubber blade or a threshold with a seal is meant to close that clearance. The gap grows when the door drops on its hinges, when a worn seal flattens or splits, when a threshold has settled, or when the door was cut down too far for a new carpet or hall floor. On a uPVC or composite door the threshold seal can also be dislodged or crushed. Which fix suits depends on which of these it is: a sprung brush, a replacement seal, re-hanging the door or planing and adding a drop-down strip. A draught excluder bag only hides the problem.

What usually causes it?

  • A worn, flattened or missing seal in the door's threshold or bottom edge
  • A door that has dropped on its hinges, opening a gap at the bottom and closing one at the top
  • A threshold or door sill that has settled or been replaced at a different height
  • A door trimmed too much when a new floor or carpet was fitted
  • A bottom brush or strip that has worn down or been torn by the door scraping
  • A letterbox, cat flap or keyhole adding to the draught nearby

Is it dangerous?

A draughty door is not dangerous in itself. Gaps that you tackle should not block permanent ventilation: Approved Document F covers background ventilation and extract ventilation in homes, and rooms with open-flued appliances need their air supply. Do not seal air vents or trickle vents to cure a draught.

Can I fix it myself?

1. Close the door in daylight and look for light at the bottom, or hold a lit incense stick near the gap and watch the smoke. 2. If the door is hanging low, tighten the hinge screws first: that often closes the gap at no cost. 3. A self-adhesive or screw-on brush or blade strip suits a small even gap. 4. For uPVC and composite doors, check the threshold seal is seated before buying anything. 5. Do not block air vents. If the door scrapes the floor, fix the hinges before fitting a seal.

When should you call a handyman?

Call a handyman for a door that has dropped, a gap over about a centimetre, a threshold that has moved, or a door that needs trimming and re-hanging. If the frame or the sill has rotted, a carpenter is the right trade.

What will the handyman actually do?

  • Check the hinges, the door alignment and the threshold to find where the gap comes from
  • Re-hang or adjust the door so the gap is even all round
  • Fit a threshold seal, a drop-down door bottom seal or a brush strip suited to the gap
  • Re-seat or replace a worn threshold seal on a uPVC or composite door
  • Refer a rotten door or frame to a carpenter

Who fixes this

Questions people ask

How do I stop a draught under my front door?

Find why the gap is there first. A dropped door needs adjusting, a worn seal needs replacing, and a small even gap can take a brush or blade strip. A draught excluder bag only works as a cover-up.

Why is there a gap under my front door?

Most commonly the door has dropped on its hinges, the seal has worn out or the threshold has moved. A door cut down too far for new flooring also leaves a gap.

Should I block the draught under every door?

No. Internal doors need a gap for air to circulate, and Approved Document F sets ventilation requirements for homes. Seal the front door, not the ventilation.

Sources & References

  1. GOV.UK: Approved Document F, Ventilation (frequently asked questions)
  2. GOV.UK: Conservation of fuel and power, Approved Document L

Need a handyman?

Describe the job and get a fixed price from a local handyman.