Skip to main content
Metal Gate Rusting

Metal Gate Rusting

A steel or iron gate has orange rust bubbling through the paint, rust stains at the joints or flaking at the hinges and base.

Low risk · Fixed by a fencing and gate installer

Updated

What's happening?

Steel and wrought iron rust when moisture reaches bare metal. A gate rusts first where water collects and where the coating is thinnest: the bottom bars, welds, hinge points, the underside of rails and any chip or scratch. Rust spreads under paint, lifting it in blisters, and once it takes hold it eats into the section, weakening the gate. A galvanised gate resists rust far longer, because the zinc coating protects the steel underneath, but painting over galvanizing needs the right preparation and a paint made for galvanised steel. The Galvanizers Association explains that coatings added to galvanised steel, called duplex systems, are used for colour and extra protection and should be formulated for galvanised steel. The fix depends on how far the rust has gone: clean back and repaint early, repair or replace sections later.

What usually causes it?

  • Paint chipped or scratched through to bare metal, letting moisture in
  • Water collecting at the bottom bars, hinges, welds or open-ended tubes
  • An old paint system that has failed and flaked
  • Coastal air or road salt speeding up corrosion
  • A gate that was not galvanised or properly primed before painting
  • Contact with damp ground or soil at the base of the gate or the posts

Is it dangerous?

Surface rust is not dangerous, but deep rust at the hinges, welds or the bottom rail can weaken a heavy gate until it drops or a section snaps. A gate that sags or drags on a hinge with rusted fixings should be looked at promptly, especially an automatic gate.

Can I fix it myself?

1. Check how deep the rust goes: surface staining, or flaking and pitting into the metal. 2. Wire-brush or sand surface rust back to bright metal. 3. Apply a rust-converting primer and then a metal paint, with enough coats. 4. On galvanised gates, use a primer and paint suited to galvanised steel. 5. Wear gloves and eye protection, and take care with old paint, which may contain lead. 6. If metal is holed or hinge fixings are corroded, stop and get it repaired.

When should you call a fencing and gate installer?

Call a gate or fencing installer if rust has eaten through a rail, a weld or the hinge fixings, if the gate sags, or if you want a rusting gate refurbished, re-hung or replaced.

What will the fencing and gate installer actually do?

  • Assess how far the rust has gone, and test welds, hinges and fixings
  • Blast or wire-brush the gate back to bright metal
  • Weld or replace corroded sections, and replace rusted hinges and fixings
  • Apply a primer and paint, or a duplex system, suited to the metal
  • Re-hang and adjust the gate so it swings and latches properly

Who fixes this

  • Gate repair and rehanging

Questions people ask

How do I stop a metal gate rusting?

Clean back rust to bright metal, prime with a rust-treating primer and repaint. A galvanised gate lasts longer, and any paint on galvanised steel should be suited to it.

Can you paint over a galvanised gate?

Yes, but the Galvanizers Association says coatings on galvanised steel should be formulated for it and applied to the paint maker's instructions.

Is a rusty gate unsafe?

Surface rust is cosmetic. Deep rust at welds, hinges and the bottom rail can weaken the gate, so check them before it becomes a safety problem.

Sources & References

  1. Galvanizers Association: Painting and powder coating on galvanised steel
  2. Galvanizers Association: Durability of galvanizing
  3. HSE: Lead in old paint

Need a fencing and gate installer?

Describe the job and get a fixed price from a local fencing and gate installer.