Skip to main content
Fence Panels Rattling In Concrete Posts

Fence Panels Rattling In Concrete Posts

Fence panels set in slotted concrete posts rattle and bang in the wind, and may work loose over time.

Low risk · Fixed by a fencing and gate installer

Updated

What's happening?

Slotted concrete fence posts hold panels in a groove, but the panel is not fixed to the post. The panel sits loose in the slot with a small gap, and in wind it moves back and forth and knocks against the concrete. Jackson's Fencing, a UK fence maker, says you cannot fix a panel to a concrete post because drilling into concrete would damage it, and that lighter or lower-grade panels flex more in the wind. The noise is a nuisance, but the movement also wears the panel edges and can loosen the fit until a panel works free. Wedges or clips fitted into the gap stop the movement. Packing it too tightly leaves no room for the panel to swell, which can split it. Where rattle is only one sign of a weak fence, the panels may be the wrong grade for the site.

What usually causes it?

  • The panel fits loosely in the post slot, with a gap on one or both sides
  • Lightweight or lower-grade panels that flex in the wind
  • Panels shrunk by drying out after fitting, widening the gap
  • An exposed site with strong gusts, with no windbreak
  • Worn panel edges that no longer fill the slot after years of movement
  • Posts set slightly out of line, so panels sit unevenly in their slots

Is it dangerous?

A rattling panel is not dangerous in itself, but a panel that has worked loose can blow out in a gale and fall onto a path, a car or a neighbour's garden. Check loose panels after strong winds.

Can I fix it myself?

1. Find which panels rattle by pushing each one. 2. Fit anti-rattle wedges or clips designed for slotted concrete posts, pushed into the gap between the panel and the post. 3. Do not pack the gap tight: leave a little room for the panel to swell. 4. Replace any panel that is split or has worn edges. 5. If the panels are light and the site is exposed, heavier panels or timber posts may be a better long-term fix.

When should you call a fencing and gate installer?

Call a fencing installer if several panels rattle or have worked loose, if posts lean, or if you want the run upgraded to heavier panels or timber posts that panels can be fixed to.

What will the fencing and gate installer actually do?

  • Check each panel and post for movement, splits and leaning
  • Fit wedges or clips to stop panels moving in the slots
  • Replace worn or split panels with a heavier grade where the site is exposed
  • Reset or replace leaning concrete posts
  • Recommend timber posts where panels can be fixed directly and securely

Who fixes this

  • Fence panel replacement
  • Fence post replacement

Questions people ask

How do I stop fence panels rattling in concrete posts?

Fit anti-rattle wedges or clips into the gap between the panel and the post. Do not pack the gap so tight that the panel cannot swell.

Why do fence panels rattle in concrete posts?

Panels are not fixed to slotted concrete posts, so they sit loose in the groove. Wind makes them move and knock, especially lighter panels.

Can I screw fence panels to concrete posts?

No. Jackson's Fencing says you cannot secure the panel to a concrete post because you cannot drill into the concrete without damaging it. Timber posts allow the panel to be fixed.

Sources & References

  1. Jackson's Fencing: Why do fence panels rattle
  2. BSI: Fences, specification for close-boarded fences

Need a fencing and gate installer?

Describe the job and get a fixed price from a local fencing and gate installer.